Make Printer to work without toner chip, no need replace new toner cartridge, hard reset or factory reset. – Samsung SL-M4070FR Firmware Fix means reprogramming of the printer’s firmware by overwriting the firmware permanent memory data, so that refilled cartridges can be used in your printer. – Reset Samsung SL-M4070FR counters one time and using forever –> the best solution. Reset Samsung SL-M4070FR counters permanent by using Firmware Fix – Unismart System supports overwriting, resetting the counter, or checking the printer ink toner chip counter. – Unismart System supports reset counters for chips of almost existing printer brands over the world: Samsung, HP, Canon, Epson, OKI, Xerox, Dell, Lexmark… – Unismart System is a device used to reset the Samsung SL-M4070FR’s toner chip counter to 0 value so that the printer can continue to work. Samsung SL-M4070FR Not Printing Troubleshooting Solutions Change new Samsung SL-M4070FR toner cartridge – Computer’s messages: low toner, empty toner, replace toner/stop, replace new cartridge, repare new cartridge, prepare toner, end of life replace new cart, toner exhausted, red light blinking error. – Samsung SL-M4070FR printer’s messages: red light blinking, imprinting. When Samsung SL-M4070FR needs to be reset: – When Samsung SL-M4070FR toner chip overload its calculated limitation, printer will be locked inspire of high toner cartridge.
That is the reason why bold printouts (high toner coverage) will make printer run out of toner quickly. If toner coverage is lower than 5%, Toner Page Yields are “1.500 – 4.500” pages. – If toner coverage is higher than 5% -> Toner Page Yields are less than “1.500 – 4.500” pages.
Following Samsung, if toner coverage is 5%, Samsung SL-M4070FR toner chip is delivered 1.500 – 4.500 pages. – Samsung SL-M4070FR toner chip contains calculated limitation that was managed by Samsung manufacturer. – Samsung SL-M4070FR’s cartridge is enclosed with a toner chip that was used to calculate toner coverage and to deliver bold or light printout quality depending on printer original printout design. – Because the Samsung SL-M4070FR printer’s toner chip has run out of counters, it will block printing and shows errors: very low toner stop error, red light/ ink light/ triangle light/ exclamation point blinking, Black/Yellow/Magenta/Cyan cartridge is very low, change new cartridge, install toner… Why does the Samsung SL-M4070FR printer startup but cannot print? – Samsung SL-M4070FR printer shows errors: low toner, empty toner, replace toner/stop, replace new cartridge, repare new cartridge, prepare toner, end of life replace new cart, toner exhausted, red light blinking error, Samsung SL-M4070FR Not Printing.
0 kommentar(er)
